If your car has an engine that is more than 10 years old, it’s likely that the gaskets on it are ready to be replaced. The water and oil passages through your engine are constantly fighting against one another, and as a result, the gaskets can start to wear down.
This can eventually cause leakage, engine damage, and even fires. When you replace the engine gaskets, you’ll want to do it as a complete job so that you can avoid any potential problems. Check online to get more information about Komatsu Suppliers in Europe.
Image Source: Google
Here are some tips on how to do it:
1. Get the right tools: You’ll need a jack and lug wrench to remove the wheel and axle assemblies, a socket set for removing the bolts holding on the engine cover, and a ratchet and extensions for tightening the bolts afterwards.
2. Check fluid levels: Make sure all of the car’s fluids are topped off before beginning work on the engine. This includes the oil, coolant, transmission fluid, brake fluid, and power steering fluid.
3. Drain and clean all of the car’s fluids: Before you start tightening the bolts, drain off all of the fluid from the car. You can then use a funnel to pour it back into its respective reservoirs.
4. Drain and remove transmission fluid: To get to a differential in an automatic transmission, you will need to drain and remove the transmission fluid that is housed in a pan under your car’s engine block or in the front under-hood compartment.
